The Dash Dock | 15W Magnetic Qi Car Mount for Jetour T2 and Traveller

节省20%
EastSupplier PlatformSKU:1005008157210172-Charging Silver

价格:
$71.72 $89.65

含税 运费在结账时计算

股票:
有现货

描述

A phone mount is the most replaced accessory in any vehicle, and almost never because it broke. It gets replaced because it was designed for a generic dashboard that does not exist. Suction cups lose grip in summer heat, vent clips block the air the cabin was built to deliver, and adhesive pads leave a ring on the trim. The fix is not a better clamp. It is a mount cut for one specific interior.

This dock is built around the Jetour T2 and Traveller center stack: the bracket follows the trim line, so it reads as part of the dash rather than an add-on clipped to it. The cradle holds the handset at navigation height without covering the screen below it, and a fifteen watt Qi coil charges through the case without a cable crossing the console. Power negotiation is automatic across fifteen, ten, seven and a half and five watts, so an iPhone, an Android flagship and an older handset all charge at their own ceiling instead of at the lowest common denominator.

Charging alignment is the detail that separates a wireless charger from a wireless charger that works. The coil tolerates up to five millimetres of transmission distance, which covers a normal protective case without forcing you to strip the phone naked every time you get in. Input runs over USB Type-C at five volts two amps, nine volts one point six seven amps or twelve volts two amps, so a standard twelve volt socket adapter is enough. The housing weighs a hundred and fifteen grams and measures roughly one hundred and twenty four by seventy nine millimetres, which keeps it light enough that the trim never carries a visible load.

The practical test of any in-car mount is a broken road at speed. Magnetic retention plus a shaped cradle keeps the phone fixed through expansion joints and speed humps, and because the coil sits behind the retention plate rather than beside it, wireless charging does not drop out when the phone shifts a millimetre. Installation is trim-safe and reversible: no drilling, no adhesive on leather, and removal leaves nothing behind at resale.

Stop bolting universal hardware onto a specific car. The dash already knows the shape.


Why a vehicle-specific mount wins

  • ✦ Cut for the Jetour T2 / Traveller center stack - the bracket follows the trim line instead of clamping onto a vent or glass.
  • ✦ 15 W Qi wireless charging with automatic negotiation across 15 W, 10 W, 7.5 W and 5 W to match the handset.
  • ✦ 5 mm transmission tolerance so normal protective cases stay on while the phone charges.
  • ✦ Magnetic retention plus a shaped cradle that holds through expansion joints, speed humps and rough tarmac.
  • ✦ USB Type-C input at 5 V/2 A, 9 V/1.67 A or 12 V/2 A - a standard 12 V socket adapter is enough.
  • ✦ 115 g housing, 124 x 79 mm - light enough that the dash trim carries no visible load.
  • ✦ Trim-safe and reversible: no drilling, no adhesive on leather, nothing left behind at resale.

Technical Specifications

  • Product name  M3 Smart Car Stand
  • Vehicle fitment  Jetour T2 / Traveller, 2024-2025 center stack
  • Wireless output  15 W / 10 W / 7.5 W / 5 W, automatic recognition
  • Transmission distance  0-5 mm through case
  • Input  USB Type-C, 5 V/2 A, 9 V/1.67 A, 12 V/2 A
  • Operating frequency  110-205 kHz
  • Protocol  Qi wireless charging with magnetic retention
  • Dimensions  124 mm x 79 mm
  • Weight  115 g
  • Installation  Trim-mounted, no drilling, removable

Where it earns its place

Ride-hail drivers in a T2 want the phone at eye level without a cable across the console. Weekend travellers want navigation visible while the passenger controls the music. Fleet buyers want a mount that does not mark the trim when the vehicle goes back at end of lease. All three cases are served by the same bracket, which is why a vehicle-specific mount costs more than a universal one and gets replaced a great deal less often.

Questions buyers ask about dash-specific mounts

Q. Will it fit a left-hand-drive Traveller?

The bracket is shaped for the Jetour T2 and Traveller center stack across the 2024 and 2025 model years. Left-hand and right-hand drive interiors share the same mounting geometry in this area, but if you have the sunroof or a modified console, send a photo of the dash before ordering and we will confirm the fit.

Q. Does it charge through a thick case?

Cases up to roughly five millimetres of total thickness charge normally. Metal plates, magnetic card holders and battery cases interrupt the coil; remove those, or use the mount purely as a holder with a cable.

Q. How fast is fifteen watts in practice?

Fifteen watts is the coil's peak, negotiated only by handsets that support it. An iPhone typically settles at seven and a half watts, a recent Android flagship at ten to fifteen. Navigation plus charging still nets positive, which is the point on a long drive.

Q. Does it block the vents or the screen?

No. The cradle sits forward of the center stack at navigation height and leaves the factory screen and the vent flow unobstructed. That is the difference between a trim-specific bracket and a vent clip.

Q. Will it leave marks on the dashboard?

The contact faces are padded and the mount is removable without adhesive. On soft-touch trim, clean the surface before fitting and avoid leaving the mount under direct sun for weeks at a time.

Q. What is included?

The mount, the trim bracket and the Type-C input lead. A 12 V socket adapter is not included, because most buyers already run one.

Customer Reviews

Customer Reviews

Based on 3 reviews
67%
(2)
33%
(1)
0%
(0)
0%
(0)
0%
(0)
L
Lucinda T.
No marks on the trim after removal

Fitted it, drove a week, then moved it to a different position. No adhesive ring, no mark on the soft touch dash. That alone justifies the price over a suction mount.

E
Emmerich R.
Charges through a thick case

Case is about 3 mm and it still charges, though it drops to 10 W instead of 15. Magnetic hold is strong over speed humps.

S
Sorcha K.
Sits like a factory part in the T2

The bracket follows the trim line so there is no vent clip hanging off the dash. Holds the phone at navigation height and 15 W wireless keeps it charging with navigation running.

Payment and Security

PayPal

您的支付信息已安全处理。我们不存储信用卡详细信息,也无法访问您的信用卡信息。

估算运费

You may also like

Recently Seen